Motoworld Singapore

Denso IU27A Iridium Spark Plug

Denso
  • S$19.00


Denso IU27A  Iridium Spark Plug 

Ignitability That's a Cut Above

With DENSO's very own U-Groove ground electrode for better spark performance
To increase ignitability, the important point is to let the flame kernel caused by the spark to grow to a large size. Normally, this can be accomplishing by widening the spark gap, however this causes spark voltage to increase, which has the opposite effect. IRIDIUM POWER uses DENSO very own U-Groove ground electrode to realize a superb ignitability while maintaining spark voltage at low levels.

Improved Horse Power(1)

Get more power with an optimal combustion cycle.
IRIDIUM POWER has a low required voltage and a high ignitability, resulting in less misfiring and no spark, the outcome being a dramatic improvement in combustion. Engine output is thus increased. The findings of a bench test using a motorcycle engine to show the improved combustion from IRIDIUM POWER is shown on the below. Compared to normal plugs, a 0.5ps (1.4%) improvement is seen in output at 110km/h.

Improved Acceleration

Increased response and acceleration performance.
IRIDIUM POWER best demonstrates its performance improvement during acceleration.IRIDIUM POWER has a 0.4 mm diameter iridium center electrode and a specially shaped ground electrode. These features combine to achieve higher ignitability and require lower spark voltage than ever before. This enables high-response driving with fewer misfires than under higher required voltage spark conditions, and fewer misfires when ignitability is difficult. As a result, acceleration improves in comparison with normal plugs.

Improved Horse Power(2)

The 0.4mm center electrode increases output under various driving conditions.
The power produced by the 0.4mm dia. iridium center electrode is IRIDIUM POWER unmatched by other plugs. The graph below compares the resulting power when IRIDIUM POWER is installed compared to other high performance plugs. Using a 0.4mm dia. fine center electrode, there is more power compared to 0.8mm and 2.5mm dia. plugs. This is what makes the difference in acceleration and in your lap time.

Improved Fuel Mileage

Even during idling ignition is assured, with less fuel consumption and less noise.
The good ignitability from the fine electrode (0.4mm) of IRIDIUM POWER draws out much more performance from the engine. Comparing a normal plug (W20FS-U) with an IRIDIUM POWER(IWF22) on a 2 cycle 50cc engine, fuel consumption improved from 41.74km/L → 43.69km/L, an improvement of about 5%.
Note: Mileage measured using a chassis dynamo; actual driving results under normal conditions may vary.

The Secret behind DENSO's Iridium Patent!

Plug electrodes conventionally have used nickel and platinum. These were not pure metals, but alloys containing other metals. Depending on the composition of the alloy, the matrix material's properties can be maximized. Using the same approach, iridium is alloyed with rhodium. The rhodium layer covers the iridium, improving the properties of the iridium. This iridium/rhodium technology was recognized by the Patent Offices of Japan and the UK, and in January 1999, a patent was granted in each respective country. (Patent Number - Japan: 2877035, UK: 2302367). Because DENSO had this patented technology, DENSO was able to make dia. of the iridium down to 0.4mm.

The most important things for plug performance are ignitability and sparkability. To make the electrode as fine as possible is the goal of spark plug manufacturers worldwide, and DENSO has taken the lead, succeeding the commercializing the 0.4mm dia. center electrode plug.

A Pattern from Spark to Ignition.

Electrodes have a quenching (cooling) affect (where the heat of the ignited flame kernel is taken away by the electrode). This cooling affect is greater with larger electrodes, sometimes causing the ignition to stop short of the stage in Figure 4. To improve ignitability, the contact area between the electrode and the flame kernel must be reduced. Improved ignitability is why IRIDIUM POWER electrodes have been made fine as possible.

Features

  • 10mm dia. X L19mm length fully threaded slant ground electrode type.
  • Harnessing the low required voltage of the 0.4mm dia. iridium, the gap is wider than in normal type (0.7 → 0.9mm). Ignitability is greatly increased.
  • By making this a single electrode, the spark location is stabilized compared to in normal types (double ground electrode), securing an ideal combustion condition.

 

Brand Model
ATK 600 Supermotard
BMW 650
BMW G450X
Buell 1125CR
BUELL 1125R
CANNONDALE C440
CANNONDALE E440
CANNONDALE EX400
CANNONDALE MX400
CANNONDALE X440
CANNONDALE XC400
KAWASAKI KZ750S
KAWASAKI Ninja
KAWASAKI Z1000
KAWASAKI Z1000A
KAWASAKI Z750S
KAWASAKI ZR1000A
KAWASAKI ZR1100C
KAWASAKI ZR1200A
KAWASAKI ZR750
KAWASAKI ZR750R
KAWASAKI ZRX1100
KAWASAKI ZRX1200
KAWASAKI ZRX1200A
KAWASAKI ZRX1200R
KAWASAKI ZX-9R Ninja
KAWASAKI ZX1100E
KAWASAKI ZX1100F
KAWASAKI ZX1200 Ninja
KAWASAKI ZX1200 Ninja ZX-12R
KAWASAKI ZX1200A
KAWASAKI ZX1200B
KAWASAKI ZX12R
KAWASAKI ZX900B
KAWASAKI ZX900C
KAWASAKI ZX900E
KAWASAKI ZX900F
KTM 250 EXC-F
KTM 250 SX-F
KTM 250 XC-F
KTM 250 XC-SW
KTM 250 XCF-W
KTM 450 SX-F
KTM 450 XC-F
KTM 505 SX
KTM 505 XC-F
SUZUKI Bandit
SUZUKI DR350
SUZUKI DR350SE
SUZUKI GSF600S
SUZUKI GSF600S Bandit
SUZUKI GSX-R600W
SUZUKI GSX-R750
SUZUKI GSX600F
SUZUKI GSX600F Kantana
SUZUKI GSX600F Katana
SUZUKI GSX750F Katana
SUZUKI TL1000R
SUZUKI TL1000S
Triumph Daytona 650
Triumph Daytona 675
Triumph Daytona 675 RR
Triumph Daytona 955i
Triumph Speed Four
Triumph Speed Triple
Triumph Speed Triple R
Triumph Sprint RS
Triumph Sprint ST
Suzuki Tiger 1050
Triumph Tiger ABS
Triumph TT600
YAMAHA FZ1
YAMAHA FZ6
YAMAHA FZ600S
YAMAHA FZS 1000
YAMAHA FZS10
YAMAHA FZS10X-FZ1
YAMAHA FZS10XC-FZ1
YAMAHA R1
YAMAHA WR 250R
YAMAHA WR 250X
YAMAHA WR250R
YAMAHA WR250X
YAMAHA YZF-R1
YAMAHA YZF-R6T
Hyosung 1125R
Kawasaki ZX900 Ninja ZX-9R
Yamaha FZS1000 FZ1
Payment Methods

© 2021 Motoworld Singapore \ Privacy Policy \ Terms & Condition

Newsletter

* E-Mail:

* First Name: